1
4
2
5
3
6
Working from the back of the
bracket, insert fl exible tube
through the nose of the front
block then bend tube and
capture in place at tail end of
elbow.
Slide plastic elbow block
assembly to desired stub out
location. Insert two screws
into each block and tighten.
Tightening screws prevents
lateral movement of blocks on
brackets and prevents elbow
from swiveling.
Bend the loose ends of the
Strong Arm brackets as close
as possible to the Plastic Bend
Support in opposite directions.
Secure each bracket
with
screws. Start with lower bracket
to keep installation level.
Installation complete.
Determine stub out height.
Secure both brackets to one
side of the stud bay.
1-800-821-3944 • www.siouxchief.com
#IS-525-PBL ©2010 SIOUX CHIEF MFG.
Strong Arm
™
with Plastic Bend Support
Inside Mount Instruction Sheet
Patent # 8,141,831
Patent # 8,061,390
Comments to this Manuals